C18 Generator Set

C18 Generator Set

Caterpillar is leading the power generation marketplace with Power Solutions engineered to deliver unmatched flexibility, expandability, reliability, and cost-effectiveness.

Generator Set Specifications
Minimum Rating
455 ekW
Maximum Rating
600 ekW
Emissions/Fuel Strategy
U.S. EPA Cert., Tier 2
Voltage
208 to 600 Volts
Frequency
60 Hz
Speed
1800 rpm
Duty Cycle
Standby, Prime
Engine Specifications
Engine Model
C18 ATAAC, I-6, 4-Stroke Water-Cooled Diesel
Bore
5.71in
Stroke
7.2in
Displacement
1106.4l
Compression Ratio
14.5:1
Aspiration
Air to Air Aftercooled
Fuel System
Electronic unit injection
Governor Type
Adem™A4
Generator Set Dimensions
Length - Maximum
5550in
Width - Maximum
80.9in
Height - Maximum
107.8in

Standard Equipment:

Air Inlet
  • Air Cleaner
 
Air Inlet System
  • Turbocharger
  • Light duty air cleaner
  • Aftercooler core
 
Cooling
  • Caterpillar extended life coolant
  • Fan drive, battery charging alternator drive
  • Coolant drain line with valve
  • Radiator and cooling fan with guard
  • Package mounted radiator
 
Exhaust
  • Exhaust flange outlet
 
Exhaust System
  • Stainless steel exhaust flex gaskets, raincap and SAE exhaust flange for customer use; shipped loose
 
Fuel System
  • Standard 8 hour open set fuel tank
 
Fuel
  • Secondary fuel filter
  • Fuel priming pump
  • Primary fuel filter with integral water separator
 
Generator And Attachments
  • Matched to the performance and output characteristics of Cat engines
  • Segregated low voltage (AC/DC) wiring panel
  • Power center, IP22
  • A frame generator - IP21 protection
  • Integrated Voltage Regulator
  • Mandatory Option circuit breaker, IEC, 3 pole, mounted in power centre
  • Integrated Voltage Regulator
 
Generator
  • IP23 Protection
  • Matched to the performance and output characteristics of Cat engines
  • Load adjustment module provides engine relief upon load impact and improves load acceptance and recovery time
 
Power Termination
  • Bus Bar
 
Control System
  • EMCP 4.2
 
Governing System
  • Cat Electronic Governor (ADEM A4)
 
Control Panel
  • EMCP 4 Genset Controller
 
Lube System
  • Lubricating oil
  • Oil drain valves
 
Mounting System
  • Captive linear vibration isolators between base and engine-generator. includes lifting provisions and termination points for coolant and lube oil drain lines
 
Mounting
  • Rubber vibration isolators
 
Starting/charging
  • 24 Volt battery with rack and cables
  • 24 volt starting motor
  • Batteries
 
General
  • Engine and alternator pre-paint, Caterpillar yellow
  • Paint - Caterpillar Yellow except rails and radiators gloss black
 

Optional Equipment:

Air Inlet System
  • Single element air cleaner
  • Dual element air cleaner
 
Exhaust
  • Industrial, Residential, Critical Mufflers
 
Generator
  • Oversize and premium generators
  • Excitation: [ ] Permanent Magnet Excited (PM) [ ] Internally Excited (IE)
  • Anti-condensation heater
 
Power Termination
  • Circuit breakers, UL listed
  • Circuit breakers, IEC compliant
 
Circuit Breakers
  • 3 Pole (IEC-100% rated) circuit breakers - Motorised
  • 4 Pole (IEC-100% rated) circuit breakers - Motorised
  • Shunt trip for IEC breaker
  • Power terminal strip
  • Circuit breaker (IEC) auxiliary contacts
  • 3 Pole (IEC-100% rated) circuit breakers - Package mounted
  • Pad-lockable circuit breaker device
  • 4 Pole (IEC-100% rated) circuit breakers - Package mounted
 
Control Panels
  • Remote monitoring software
  • Load share module
  • Local & remote annunciator modules
  • EMCP (4.2) (4.3) (4.4)
  • Digital I/O module
 
Control System
  • Local alarm modules
  • Volt free contact
  • Local alarm horn
  • Remote annunciator modules
  • Oil temperature displays
  • Protective devices: Earth fault relay - earth leageage ground fault relay - Overload shutdown via breaker - Low fuel level alarm - Low fuel level shutdown - high fuel level alarm - Fuel level sensor
  • EMCP 4.4
 
Cooling System
  • Low coolant temperature alarm
  • Radiator duct flange
 
Enclosures
  • Sound attenuated enclosures
 
Starting/charging
  • Jacket water heater
  • Battery chargers
  • Heavy-duty starting system
  • Oversize batteries
  • Charging alternator
 
Exhaust System
  • 8 and 10 inch GP flanges
  • 8 and 10 inch elbow kits
  • Engine mounted muffler
  • 10, 25 and 35 end in / end out mufflers
  • Manifold and Turbocharger guard
 
Fuel System
  • Manual fuel transfer pump
  • Fuel transfer system
  • Integral - Duel wall fuel tank base
 
General
  • Sound attenuated, weather protective or high ambient weather protective enclosure
  • Integral & sub-base UL listed dual wall fuel tanks
  • CSA Certification
  • Automatic transfer switches (ATS)
  • The following options are based on regional and product configuration:
  • Single or dual wall sub-base fuel tanks
  • EU Certificate of Conformance (CE)
  • EEC Declaration of Conformity
  • UL 2200 package
  • Single or dual wall integral fuel tanks
  • Seismic Certification per applicable building codes: IBC 2000, IBC 2003, IBC 2006, IBC 2009, CBC 2007
  • Narrow, Wide or Skid Base
  • Enclosures: sound attenuated, weather protective
 
Generator And Attachments
  • Space heaters
  • A frame CIP generator
  • Permanent magnet excitation
  • LC frame generator
  • A frame oversize generator
  • Ingress protection
  • LC frame CIP generator
  • LC frame oversize generators
 
Lube System
  • Manual sump pump
 
Starting And Charging
  • Battery disconnect switch
  • Jacket water heaters
  • 5 Amp battery charger
 

    This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

    Share This Product