DG200-2 (3 phase)

DG200-2 (3 phase)

DG200-2 (3 phase)

Caterpillar is leading the power generation marketplace with Power Solutions engineered to deliver unmatched flexibility, expandability, reliability, and cost-effectiveness.

Generator Set Specifications
Frequency
60 Hz
Natural Gas Rating
200 eKW
Emissions/Fuel Strategy
U.S. EPA Certified for Stationary Emergency Application
Displacement
864.71in
Fuel Type
Natural Gas
Speed
1800 rpm
Engine Specifications
Engine Model
14.2 L, Inline 6, 4 Cycle, Spark - Ignited
Fuel System
Carburetor, Down Draft
Aspiration
Turbocharged-Aftercooled
Governor Type
Electronic
Compression Ratio
9.5:1
Bore
5.31in
Stroke
6.5in
Generator Set Dimensions
Length
127.95in
Width
52.93in
Height
67.37in
Weight
5756lb

Standard Equipment:

Cooling
  • Closed coolant recovery system
  • Factory-installed radiator
  • 50/50 Ethylene glycol antifreeze
  • Radiator and cooling fan complete with protective guards
  • Standard ambient temperatures up to 50°C (122°F)
 
Air Inlet
  • Single element air filter
 
Fuel
  • Primary and secondary fuel shut-off
  • Low fuel pressure switch
  • Fuel pressure test po
  • Natural Gas or LP Vapor
  • NPT connection
  • Dual lock off valves
 
Exhaust
  • Exhaust outlet with 3” pipe
 
Generator
  • Permanent magnet excitation
  • Full load capacity alternator
  • Class H insulation material
  • Permanent magnet excitation
  • Integrated Voltage Regulator
  • Matched to the performance and output characteristics of Cat engines
  • Class H insulation material
  • Full load capacity alternator
  • IP23 Protection
 
Controls
  • EMCP 4.2 Series generator set controller
 
Mounting
  • Vibration isolaton (puck type)
  • Rubber vibration isolators
 
Electric Power - Package Serial Number Prefix
  • Battery charging alternator
 
Electric Starting And/or Prelube
  • Battery cables
  • Solenoid activated starter motor
  • Engine electrical system
  • Solenoid activated starter motor
 
Governor
  • Electronic governor (non adjustable)
 
Control Panel
  • EMCP 4.2 Series generator set controller
 
Starting/charging
  • Batteries with rack and cables
  • 12 volt starting motor
 

Optional Equipment:

Starting/charging
  • Jacket water heater
  • Battery heater
  • Charging alternator
  • Battery charger – UL Listed 10 amp
 
General
  • Enclosures: sound attenuated, weather protective
  • Suitable for Use as Service Equipment (SUSE)
  • Automatic transfer switches (ATS)
  • UL 2200 package
  • CSA Certification
 
Generator
  • Thermal magnetic or electronic trip MCCBs
  • Anti-condensation heater
  • Shunt trip and auxiliary contact breaker
  • Anti-condensation heater
  • Excitation: [ ] Permanent Magnet Excited (PM)
  • Oversize and premium generators
 

    This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

    Share This Product